How To Fix A Torn Wire. Use a wide crimping tool which will provide a good crimp of the spliced wire. You are looking at a swaged cable end specifically a threaded tensioning type of end.
If you need to buy the equipment then go for the soldering iron solder but also get shrink tube to insulate the exposed wire. Step 1 Sand one side of each half of the broken wire using very fine grit sandpaper. Thank you will give this a.
Peel up the end of the tape from a roll of electrical tape and center it over the area of the cable with the exposed wire.
Use wire nuts to connect the ends together. But youre in luck as my searches found swageless cable. Then using a flat blade screw driver or razor blade hold the top layer down while sliding off the soldering iron and putting blade in. Cut back enough insulation for it to wire or splice with the end s of the existing wire.
